Installing The Left Control Panel; Removing The Right Control Panel - Dell EMC PowerEdge R750xs 60KKP Installation And Service Manual

Installing the left control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1. Route the control panel cable and the VGA cable through the cable clip, the guide slots in the system and connector on
system board.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
2. Close and secure the cable guiding latch.
3. Align and insert the left control panel assembly in the slot on the system.
4. Using the Phillips #1 screwdriver, tighten the screws that secure the left control panel assembly to the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 130. Installing the left control panel
Next steps
1. Replace the cooling fan cage
2. Replace the air shroud.
3. Replace the drive backplane
4. Follow the procedure listed in the

Removing the right control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the drive backplane
134 Installing and removing system components
Safety instructions.
Before working inside your
assembly.
cover.
After working inside your
Safety instructions.
Before working inside your
cover.
system.
system.
system.