Advertisement
Control Features
1. Temperature Display: The digital readout displays the ambient temperature, set point and cycle time, system status, and diagnostic error codes.
2. Steam Icon: When illuminated the steam cycle is running.
3. Water Icon: This is also illuminated during a steam bath cycle, to indicate water is boiling inside the steam generator.
4. Menu Button: Used to change cycle time, and switch between ºF and ºC. When steam is off, pressing this button will toggle between these set-
tings. The settings are changed with the up/down arrow buttons.
5. Stop Button: Pressing this button will stop the current steam cycle or menu mode.
6. User 1 Button: Starts the user one cycle and is the up arrow when changing Menu settings. Pressing this button while in a cycle will change the
temperature and remaining time left on that cycle.
7. User 2 Button: Starts the user two cycle and is the down arrow when changing Menu settings. Pressing this button while in a cycle will change
the temperature and remaining time left on that cycle.
IMPORTANT: This control must be installed inside the steam room for proper operation of the system and will ONLY function with 5GE-SMP series
generators.
Cleaning instructions: use a damp cloth and mild soap. Do NOT use abrasive cleaners which might scratch the surface or the base of the control.
5CH-250 and 5CH-550 Series Controls
1
4
6
2
2
3
5
7
113376 Rev. E
Advertisement
