Hydraulic Valve Solenoid Functions; Operating Tips - Toro 03672 Operator's Manual

Hydraulic Valve Solenoid
Functions
Use the list below to identify and describe the different
functions of the solenoids in the hydraulic manifold.
Each solenoid must be energized to allow function
to occur.
Solenoid
SP2 Front reel circuit
Rear reel circuit
SP1
SVRV Lift/lower cutting units
SV1 Lift/lower front cutting units
SV3 Lift/lower rear cutting units
SV2 Raise any cutting units

Operating Tips

Familiarization
Before mowing grass, practice operating the machine
in an open area. Start and stop the engine. Operate
in forward and reverse. Lower and raise the cutting
units and engage and disengage the reels. When you
feel familiar with the machine, practice operating up
and down slopes at different speeds.
Warning System
If a warning light comes on during operation, stop the
machine immediately and correct the problem before
continuing operation. Serious damage could occur if
you operate the machine with a malfunction.
Mowing
Start the engine and move the engine speed switch
to the Fast position. Move the Enable/Disable switch
to the Enable position and use the Lower Mow/Raise
lever to control the cutting units (the front cutting units
are timed to lower before the rear cutting units). To
move forward and cut grass, press the traction pedal
forward.
Transport
Move the Enable/Disable switch to the Disable position
and raise the cutting units to the transport position.
Move the Mow/Transport lever to the transport
position. Be careful when driving between objects so
you do not accidentally damage the machine or cutting
units. Use extra care when operating the machine on
slopes. Drive slowly and avoid sharp turns on slopes
to prevent roll overs. Lower the cutting units when
going downhill for steering control.
Function
42