Toro 03672 Operator's Manual page 23

Settings
Menu Item
Units
Language
LCD Backlight
LCD Contrast
Front Backlap Reel Speed
Rear Backlap Reel Speed
Protected Menus
Auto Idle
Blade Count
Mow Speed
Height of cut (HOC)
F Reel RPM
R Reel RPM
* Only "operator-faced" text is translated. Faults,
Service, and Diagnostics screens are "service-faced".
Titles will be in the selected language, but menu items
are in English.
About
Menu Item
Model
SN
Machine Controller Revision
InfoCenter Revision
CAN Bus
Description
Controls the units used on the
InfoCenter. The menu choices
are English or Metric
Controls the language used
on the InfoCenter*.
Controls the brightness of the
LCD display.
Controls the contrast of the
LCD display.
Controls the speed of the front
reels in backlap mode.
Controls the speed of the rear
reels in backlap mode.
Allows a person authorized
by your company with the
PIN code to access protected
menus.
Controls the amount of time
allowed before returning the
engine to low idle when the
machine is stationary.
Controls the number of blades
on the reel for reel speed.
Controls the ground speed for
determining the reel speed.
Controls the height of cut
(HOC) for determining the reel
speed.
Displays the calculated reel
speed position for the front
reels. The reels can also be
manually adjusted.
Displays the calculated reel
speed position for the rear
reels. The reels can also be
manually adjusted.
Description
Lists the model number of the
machine.
Lists the serial number of the
machine.
Lists the software revision of
the master controller.
Lists the software revision of
the InfoCenter.
Lists the machine
communication bus status.
Protected Menus
There are 7 operating configuration settings that are
adjustable within the Settings Menu of the InfoCenter:
auto idle time delay, Blade Count, Mow Speed, Height
of Cut (HOC), F Reel RPM and R Reel RPM. These
settings can be locked by using the Protected Menu.
Note:
At the time of delivery, the initial password
code is programmed by your distributor.
Accessing Protected Menus
Note:
The factory default PIN code for you machine
is either 0000 or 1234.
If you changed the PIN code and forgot the
code, contact your Authorized Toro Distributor for
assistance.
1. From the M
AIN
scroll down to the S
right button (Figure
2. In the S
ETTINGS
scroll down to the P
the right button
23
M , use the center button to
ENU
M and press the
ETTINGS ENU
26).
Figure 26
M , use the center button to
ENU
M and press
ROTECTED ENU
(Figure 27A).
g028523