Toro 03672 Operator's Manual page 19

Traction Pedal
The traction pedal (Figure
reverse operation. Press the top of the pedal to move
forward and the bottom to move rearward. Ground
speed depends on how far you press the pedal. For
no load, maximum ground speed, fully press the pedal
while the engine speed setting is in the Fast position.
To stop, reduce foot pressure on the traction pedal
and allow it to return to the center position.
Figure 20
1. Traction pedal
2. Mow speed limiter
3. Spacers
Mow Speed Limiter
When the mow speed limiter
it will control the mow speed and allow the cutting
units to be engaged. Each spacer adjusts the mowing
speed by .8 kph (½ mile per hour). The more spacers
you have on the top of the bolt, the slower you will go.
For transport, flip back the mow speed limiter and you
will have maximum transport speed.
Brake Pedal
Press the brake pedal (Figure
Parking Brake
To engage the parking brake,
on the brake pedal and press the top forward to latch.
To release the parking brake, press the brake pedal
until the parking brake latch retracts.
20) controls the forward and
4. Brake pedal
5. Parking brake
6. Tilt steering pedal
(Figure 20) is flipped up
20) to stop the machine.
(Figure 20) push down
Tilt Steering Pedal
To tilt the steering wheel towards you, press the foot
pedal (Figure 20) down, and pull the steering tower
toward you to the most comfortable position and then
release the pedal.
Engine Speed Switch
The engine speed switch
to change the engine speed. By momentarily tapping
the switch, the engine speed can be increased or
decreased in 100 rpm increments. By holding the
switch down the engine will automatically move to
High or Low idle, depending on which end of the
switch is depressed.
g003955
1. Lower mow/raise control
lever
2. Key switch
3. InfoCenter
Enable/Disable Switch
Use the enable/disable switch
conjunction with the lower mow/raise control lever to
operate the cutter heads.
InfoCenter
The InfoCenter LCD display shows information about
your machine such as the operating status, various
diagnostics and other information about the machine
(Figure 21).
Key Switch
The key switch
On/Run, and Start.
19
(Figure 21) has two modes
Figure 21
4. Enable/disable switch
5. Engine speed switch
6. Headlight switch
(Figure
(Figure 21) has three positions: Off,
g021208
21) in