Communication Setting - Samsung TECHWIN SAMS Pro User Manual

System Management

COMMUNICATION SETTING

In Communicating Setting, you can setup communication environments of Site and Loop settings, required for system
operation. (This is not available in SAMS Pro Lite.)
Site Setting [Add]
Site means a location that is installed with a system; generally, one site is installed with one communication server,
usually SAMS Pro Communication Server. Below describes how to setup a Site's name and confi guring
communication settings for the communication server.
1. From the upper menu, select [System Management] > [Site Setting].
2. Click Add <

J
If a site has been newly added, Site Setting of SAMS Communication Server Pro should be done again.
3. Enter the [Site].
4. Enter the IP address of the computer that is installed with SAMS Communication Server Pro.

J
Enter the IP address that is assigned to the PC.
5. Check the port. It is recommended to use the default 51008.

J If this port is changed, communication to the SAMS Communication Server Pro may not establish. If changed this
port, make the same change to the SAMS Communication Server Pro too.
6. Check whether the [Use] is checked.

J
If [Use] is not checked, communication to the corresponding communication server will not establish. This can be
used when intended not to connect temporarily to a specifi c server.
7. By using the [Connection Test], check if SAMS Pro properly connects to the SAMS Communication Server Pro.
8. Click Save <
9. Modify – Use [Quick Search] at the top toolbar to fi nd desired data for modifi cation, change as necessary, and
click < > to save changes.
10. Delete – Use [Quick Search] at the top toolbar to fi nd desired data for deletion, select desired data to be
deleted, and click <
24_ System Management
> in the tool bar.
> in the tool bar.
> to delete. If you are prompted to delete it, click [Yes].