Table of Contents
Advertisement
6.8 Assembling the start/stop control
1
Fit the new stop control (A) and tighten screw (B)
in place with a torque of 1 Nm. Slide in the stop
control in the rubber sleeve C and hook the sleeve
on the guide taps. See figure 14.
2
Fit the cables as outlined in Figure 15.
3
Attach the air filter holder. See the "Assembling the
carburetor" chapter.
4
Assemble the air filter and cylinder cover.
6.9 Resistance test - stop function
Clean the contact areas and check resistance in
the following way:
Test the resistance by connecting a multimeter
as outlined in figure 16. NOTE! The power switch
must be in the "on" position to get the correct
reading. See figure 16.
The stop switch is in the "on" position when the
button is held down (see figure 16) and in the "off"
position when the button is in neutral.
Resistance can be 0.5 Ohm at most with the power
switch in the "on" position.
IMPORTANT! If the AutoTune connector is used, it
must be remounted in the mating connector after
use. See figure 17. Always start the chain saw after
service and confirm that the stop function is work-
ing.
Fig 14
Fig 15
Fig 16
Fig 17
Safety equipment
20
English –
Advertisement
Chapters
Table of Contents
