Page 2
Rafter Assembly Instructions Short Rafter Section Short Rafter Section ATTENTION: The pre-punched purlin mounting holes in the short rafter section are not spaced evenly. Before assembly, measure from the end of the short rafter section to the set of pre-punched purlin mounting holes that is 39-7/16"...
Page 3
Side Profile Connection Details When additional rafters are added to a standard building to change the rafter spacing from 6' on-center to 4' on-center, cable patterns may change for some building lengths. The Side Profile diagrams in this guide show the cable patterns for buildings with 4' on-center rafter spacing.
Page 4
Side Profile - 35' x 36' (4' Rafter Spacing) ATTENTION: Cable pattern is the same for paneled greenhouse frames where the purlins run on top of the rafters. Sample frame shows the purlins attached to the underside of the rafters. Your frame may differ. Rafters Purlins 108871 Strut...
Page 5
Side Profile - 35' x 40' (4' Rafter Spacing) ATTENTION: REPLACE THE 108872 STRUT SENT WITH YOUR BUILDING WITH THE SHORTER 108871 STRUT INCLUDED IN THIS ADAPTOR KIT. FOUR (4) OF THE Rafters Purlins ORIGINAL 108873 SINGLE ROLL-FORM CABLE BRACKETS WILL NOT BE USED WHEN THE RAFTER SPACING CHANGES FROM 6' ON-CENTER...
Need help?
Do you have a question about the R035B00000F and is the answer not in the manual?
Questions and answers