Advertisement
Quick Links
Corrugated Polycarbonate End Panel Kit
©2009 ClearSpan™
All Rights Reserved. Reproduction
is prohibited without permission.
Revision date: 04.13.09
ClearSpan
30' Wide & 35' Wide
Diagram shows the end wall kit without a door. (Door purchased separately.)
™
STK#
R030A00007 (30' Wide)
R035A00007 (35' Wide)
1
Advertisement
Related Manuals for ClearSpan R030A00007
Summary of Contents for ClearSpan R030A00007
- Page 1 ™ Corrugated Polycarbonate End Panel Kit 30' Wide & 35' Wide Diagram shows the end wall kit without a door. (Door purchased separately.) STK# R030A00007 (30' Wide) ©2009 ClearSpan™ R035A00007 (35' Wide) All Rights Reserved. Reproduction is prohibited without permission.
-
Page 2: Table Of Contents
Table of Contents CORRUGATED PC PACKAGE: READ THIS BEFORE Important Information ........3 YOU BEGIN End Panel Installation ........5 Shelter Care and Maintenance ......8 The corrugated PC package accessory is designed to Quick Start Guide ..........9 attach to the end wall framing kit (R035A00001) after the Polycarbonate Panels - 30' Wide .... -
Page 3: Important Information
BEGIN TO ASSEMBLE THE END WALL KIT. The following list identifies the main tools needed to assemble the end wall. Additional tools and supports may Thank you for purchasing this ClearSpan™ Corrugated be needed depending on the structure, location, and Polycarbonate Kit. When properly assembled and application. - Page 4 Important Information ASSEMBLY PROCEDURE PARTS IDENTIFICATION Following the instructions as presented will help ensure The following graphics and photos will help you identify the proper installation of the end panels. The steps the different parts. (Some parts are not shown.) outlining the assembly process are as follows: Verify that all parts are included in the shipment.
-
Page 5: End Panel Installation
End Panel Installation END PANEL INSTALLATION Set the first 50" x 12' 2" panel in place as shown with the side edge aligned with the center of the end rafter The steps that follow describe one way to complete the and the bottom edge flush against the ground. - Page 6 End Panel Installation END PANEL INSTALLATION (continued) TOP VIEW Secure the panel to the end frame girt using Tek screws and neo-bonded washers inserted every 6" or Girt so (see drawing A). Do not install Tek screw into the valley where the next Corrugated Panel panel overlaps the first.
- Page 7 End Panel Installation END PANEL INSTALLATION (continued) With the bottom row of panels installed, measure from the top of the end rafter to the bottom of the top girt. Trim excess panel Use this measurement to cut the first section of a 50"...
-
Page 8: Shelter Care And Maintenance
• Depending on the contents, construction of the shelter, shelter materials, and shelter location, the potential for condensation exists. ClearSpan™ offers several items that can be used to alleviate a condensation condition. Please contact a ClearSpan™ representative for additional information. -
Page 9: Quick Start Guide
Quick Start Guide IMPORTANT: Diagrams throughout this manual show the end panels installed in line with the centers of the end rafter leg/ground posts. For buildings that include sidewall polycarbonate panels, shift the position of the end panels as needed so these panels meet the sidewall panels and create a finished QUICK START GUIDE corner. -
Page 10: Polycarbonate Panels - 30' Wide
Revision date: 04.13.09... -
Page 11: Polycarbonate Panels - 35' Wide
Revision date: 04.13.09...
Need help?
Do you have a question about the R030A00007 and is the answer not in the manual?
Questions and answers