Replacing The Fuses - Toro STX-38 EFI Operator's Manual

Stump grinder with intelli-sweep
Table of Contents

Advertisement

Cleaning the Battery
Note:
Keep the terminals and the entire battery case
clean, because a dirty battery discharges slowly.
1.
Park the machine on a level surface, engage the
parking brake, and lower the grinder.
2.
Shut off the engine and remove the key.
3.
Remove the battery from the machine;
Removing the Battery (page
4.
Wash the entire case with a solution of baking
soda and water.
5.
Rinse the battery with clear water.
6.
Coat the battery posts and cable connectors with
Grafo 112X (skin-over) grease (Toro Part No.
505-47) or petroleum jelly to prevent corrosion.
7.
Install the battery; refer to
(page
29).
Installing the Battery
1.
Using the fasteners previously removed, install
the positive (red) battery cable to the positive (+)
battery terminal
(Figure
2.
Slide the red terminal boot onto the positive
battery post.
3.
Using the fasteners previously removed, install
the negative (black) battery cable to the negative
(-) battery terminal
4.
Secure the battery using the bar and wing nuts
(Figure
41).
Important:
Ensure that the battery cables do not
contact any sharp edges or each other.
Servicing a Replacement Battery
The original battery is maintenance-free and does not
require service. For servicing a replacement battery,
refer to the battery manufacturer's instructions.
28).
Installing the Battery
41).
(Figure
41).

Replacing the Fuses

There are 4 fuses in the electrical system. They are
under the control panel on the left side
Start circuit
Not used
Cooler fan circuit
Headlight (optional)
1. Fuse block
29
(Figure
30 A
5 A
20 A
15 A
Figure 43
43).
g019854

Advertisement

Table of Contents
loading

This manual is also suitable for:

23214

Table of Contents