Replacing The Fuses; Drive System Maintenance; Servicing The Tracks - Toro STX-38 Operator's Manual

Replacing the Fuses

There are 4 fuses in the electrical system. They are under the
control panel on the left side (Figure 43).
Start Circuit
Not used
Cooler fan Circuit
Headlight (optional)
Figure 43
1. Fuse block
Drive System
Maintenance
30 amp

Servicing the Tracks

25 amp
20 amp
15 amp
Cleaning the Tracks
Service Interval: After each use
Check the tracks for excessive wear and clean them
periodically. If the tracks are worn, replace them.
1. Lower the grinder.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Using a water hose or pressure washer, remove dirt
from each track system.
Important: Ensure that you use high-pressure water to
wash only the track area. Do not use a high-pressure
washer to clean the rest of the machine. High-pressure
washing can damage the electrical system and hydraulic
valves or deplete grease.
Important: Ensure that you fully clean the wheels and
the drive sprocket (Figure 44).
1. Road wheels
2. Drive sprocket
Checking and Adjusting the Track
Tension
Service Interval: After the first 50 hours
Every 100 hours
To check the tension of each track, place 45 lb (20.4 kg) on
the track midway between the front road wheel and the drive
sprocket. The track should flex no more than 1/4 to 3/8
inch (0.6 to 1 cm). If it does, adjust the track tension using
the following procedure:
30
Figure 44
3. Track