Table of Contents
Advertisement
3.
Loosen the 2 bolts securing the bottom shield
sequentially until the shield is free
Figure 25
1. Bottom shield
4.
Pull the shield back and out of the machine.
5.
To install the shield before operating the
machine, slide the bottom shield into the
machine so that it rests on all 4 tabs and secure
it with the 2 bolts you loosened previously
(Figure
25).
Note:
You may need to lift up on the bottom
shield to ensure that it rests on the front tabs.
(Figure
25).
g019847
2. Bolts
Lubrication
Greasing the Machine
Service Interval: Before each use or daily (Grease it
immediately after every washing.)
Grease Type: General-purpose grease
1.
Park the machine on a level surface, engage the
parking brake, and lower the grinder.
2.
Shut off the engine and remove the key.
3.
Clean the grease fittings with a rag.
4.
Connect a grease gun to each fitting
through
Figure
5.
Pump grease into the fittings until grease begins
to ooze out of the bearings (approximately 3
pumps).
6.
Wipe up any excess grease.
20
(Figure 26
28).
Figure 26
Figure 27
g019848
g319421
Advertisement
Table of Contents
