PEERLESS PLA 60-UNL Installation And Assembly Manual page 7

Table of Contents

Advertisement

Installation to Concrete Wall
• Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
• Never exceed the Maximum UL Load Capacity of 175 lb (79 kg).
• Never mount this product to metal studs.
IMPORTANT! Concrete must be 2000 psi density minimum.
Note: Fasteners for concrete walls are not included,
order TWO #ACC 224 accessory kits for installation
on concrete walls.
Use wall plate (A), making sure that it is level, as a
1
template to mark holes. The top mounting slots should
be located .36" above the desired screen center for PLA
60-UNL, PLA 60-UNL-S, PLA 60-UNLP, PLA 60-UNLP-S
and RTPLA 60-S and .43" below the desired screen
center for PLAV 60-UNL, PLAV 60-UNL-S, PLAV 60-
UNLP and PLAV 60-UNLP-S. Drill 5/16" (8 mm) dia.
holes to a minimum depth of 3" (76 mm). Insert anchors
in holes flush with wall as shown (right). Place wall plate
(A) over anchors and secure with 5/16 x 3" wood screws
(O) and washers (P).
WARNING
• Tighten wood screws so that wall plate is firmly
attached, but do not overtighten. Overtightening can
damage screws, greatly reducing their holding power.
• Never tighten in excess of 80 in • lb (9 N.M.).
WARNING
• Always attach concrete expansion anchors directly to
load-bearing concrete.
• Never attach concrete expansion anchors to concrete
covered with plaster, drywall, or other finishing mate-
rial. If mounting to concrete surfaces covered with a
finishing surface is unavoidable, the finishing surface
must be counterbored as shown below. If plaster/
drywall is thicker than 5/8", custom fasteners must be
supplied by installer (Not evaluated by UL).
INCORRECT
mounting
plate
plaster/
dry wall
CORRECT
mounting
concrete
plate
plaster/
dry wall
WARNING
1
Drill hole(s) and insert anchor(s)
2
Place plate over anchor(s) and secure with screw(s)
3
Tighten all fasteners
O
concrete
7 of 13
mounting
plate
concrete
anchor
P
A
ISSUED: 06-05-06 SHEET #: 202-9141-3 08-17-06
concrete
surface
concrete
anchor
concrete
anchor

Advertisement

Table of Contents
loading

Table of Contents