Installation And Connection; For The Installer; Levelling The Cooker; Your New Cooker - Bosch HCE7443 3R Series Instruction Manual

Free standing cooker
Table of Contents

Advertisement

Installation and connection

Electrical connection
The appliance must be connected to the mains by a licensed
expert. The regulations of your electricity supplier must be
observed.
Any damage arising from the appliance being connected
incorrectly will invalidate the guarantee.
Caution!
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.

For the installer

An all-pole isolating switch with a contact gap of at least
3 mm must be present in the installation circuit. This is not
necessary if the appliance is connected by a plug that is
accessible to the user.
Electrical safety: The cooker corresponds to safety class I
and may only be used in conjunction with a safety earth
terminal.
A type H 05 VV-F or equally rated lead must be used to
connect the appliance.

Your new cooker

Here you will learn about your new cooker. We will explain the
control panel, the hob and the individual operating controls.

General information

The design depends on the respective appliance model.

Levelling the cooker

Always place the cooker directly on the floor.
Pull out the plinth drawer and lift it up and out.
1.
There are adjustable feet at the front and rear on the inside of
the plinth.
Use an Allen key to raise or lower the adjustable feet as
2.
necessary until the cooker is level (picture A).
Push the plinth drawer back in (picture B).
3.
Wall fixing
To prevent the cooker from tipping over, you must fix it to the
wall using the enclosed bracket. Please observe the installation
instructions for fixing the oven to the wall.
You will find information on the cooking compartment and the
accessories.
Explanations
1
Hob
2
Hotplate knob
3
Function selector, operating switches and display
panel, temperature selector
4
Appliance cooling
5
Oven door
6
Plinth drawer
Control knobs
The control knobs can be pushed in and remain pressed down
when they are in the "out" position. Press down on the control
knob again to release it back up.
7

Advertisement

Table of Contents
loading

Table of Contents