Table of Contents
Advertisement
3. Erasing Customer Data from the Hard Disk Drive
Before a device is removed from the FXO Center, the HDD must be initialized using
the "Initialize All Data/Settings" function on the imageRUNNER ADVANCE device.
This is done in the user mode with the following steps:
a. Select [Settings/Registration].
b. Log into the device using the center password (center number).
c. Select [Management Settings].
d. Select [Data Management].
e. Select [Initialize All Data/Settings].
f. Select [OK] to initialize the HDD.
Important
Once the process has been run, the Hard Disk Drive Erase Form, found on
e-Support and in the Appendix of this document, should be completed by the
technician and signed by the Center Manager. It is the Technician's
responsibility to scan and e-mail the completed form to the e-mail address
indicated on the form. This is to make sure that that Canon has complied with
this data security requirement.
imagePRESS C750 with imagePRESS Server G100 Configuration and Installation Guide
7
Advertisement
Table of Contents
