Canon FedEx Office imagePRESS C750 Configuration And Installation Manual page 29

Network Setup
Power-up and verify that the imagePRESS Server G100 connects to the engine, then
proceed with setup. Once enabled and the imagePRESS Server G100 is detected by
the engine, the Fiery icon will appear on the Main Menu of the Canon User Interface.
Please Note: It may take up to 7 minutes for the imagePRESS Server G100 to
boot and be detected by the engine.
The network settings will be configured in this step. Using the Canon UI and Fiery
Button follow the steps below to access the network configuration. The remaining
configuration settings of the imagePRESS Server G100 will be configured using
Command Workstation in section [A] after adding the device to Command Workstation.
1. Press the Fiery Button as shown above
2. Press the Cog at the bottom of the screen  Zoom  75%  OK (This will
ensure you can see the entire screen)
3. Press Tools  Setup  enter password [Fiery.1]  [Login]
4. Press Network  IPv4  uncheck [Get IP address automatically]  Enter [IP
address], [Subnet Mask] and [Gateway] as explained in Chapter 5.
Note: the Subnet Mask must match the Subnet Mask of the other printers in the
center.
5. Uncheck [Get DNS address automatically] then enter [Primary DNS] 
[192.112.46.53] and [Secondary DNS]  [192.112.46.153]
6. Uncheck [Use WINS]
7. Scroll up, select [Save Changes]
8. Press [Exit Setup]  [Reboot Now]
9. The controller should come to an idle state within 7 minutes. Once idle, proceed
to the next section.
imagePRESS C750 with imagePRESS Server G100 Configuration and Installation Guide 29