Canon FedEx Office imagePRESS C750 Configuration And Installation Manual page 63

imagePRESS C750 Post Installation Checklist
Date: ________________________
Model Number: ________________
Before leaving the FedEx Office center, all of the items in this chapter must be verified. Put a check mark
in the checkbox once this is done. If you cannot verify an item in this checklist, the installation is
considered incomplete. Take the action noted in the "Action" section of the table below to complete the
installation, or refer to the appropriate section of this guide.
This imagePRESS C750 Post Installation Checklist, the Certification of Canon Machine Hard Disk
Drive Erase, and the Training Checklist for the imagePRESS C750, must be scanned and emailed to:
fxo_order_management@cusa.canon.com
1.
The imagePRESS C750 is copying and scanning.
Action: Contact Canon's TSC (Technical Support Center) for assistance at 1-800-528-2830.
For steps 2 – 5: If they cannot be completed due a potential FedEx Office IT issue, the FedEx Office
manager on duty should contact their Field Technology Specialist or FedEx Office IT. FedEx Office has
agreed to have technology resources available to address these concerns immediately.
1. The imagePRESS C750 is networked and printing from a DPW.
2. The print driver was installed on all DPWs.
3. The Communication Test [Com Test] was successful. A Com Test is performed to
verify the device can communicate with Canon for reporting purposes.
4. The Center Manager or their designee was handed a Configuration Page print.
5. The Quality Validation Visual Inspection/Comparison was completed and successful.
The Technician and Center Manger must also acknowledge this has been
completed by signing at the bottom of this form.
6. The Color Verification Measurement was successful.
7. A CP Print [Canon Engine Report], Configuration page, and PS Test page have been
left in the service holder on the back of the imagePRESS C750.
8. The Hard Disk(s) were erased from any devices being removed and the Hard Disk
Erase form was signed by the Center Manager.
9. Training was completed and the Training Checklist was signed by the Technician and
Center Manager.
Quality Validation Visual Inspection was completed:
Technician Signature: ____________________ Center Manager: Signature ______________________
Installation was completed:
Technician Signature: ____________________
imagePRESS C750 with imagePRESS Server G100 Configuration and Installation Guide
Checklist Item
Center Number: ________________
Serial Number: _________________
Check if
Confirmed










63