Table of Contents
Advertisement
Functions
A/C unit settings
Settings for
from the
each group of
LonWorks
indoor units
Settings for all units
A/C unit status notifications made
to the LonWorks
Configuration properties
(*1) When a temperature above the upper limit of the temperature which can be set by the indoor units has been specified,
it will be set to the upper limit; conversely, when a temperature below the lower limit has been specified, it will be set to
the lower limit.
(*2) Two options can be selected using the setting switch from among remote-controller prohibit, fan speed setting, air
direction setting and filter sign.
(*3) When indoor units are under group control, an alarm is determined to have occurred when the alarm occurs at one or
more of the units.
(*4) The number of the indoor unit at which the alarm has occurred is notified. This makes it possible to identify at which
indoor unit of the indoor unit group the alarm has occurred.
(*5) When indoor units are under group control, the room temperature of the main unit in the group is notified.
(*6) When an alarm occurs at one or more indoor units, the alarm code is notified as the indoor unit status.
(*7) All the data which can be output is output at the set interval.
(*8) The same data is not output continuously at the set interval.
Start/stop
Temp. setting(*1)
Operation mode
Option 1 settings(*2)
Option 2 settings(*2)
Emergency stop
Start/stop
Temp. setting
Operation mode
Option 1 settings(*2)
Option 2 settings(*2)
Alarm status(*3)
Indoor units with active alarms(*4)
Room temp(*5)
A/C unit status(*6)
(*7)
Transmission interval settings
Minimum time secured
for transmission(*8)
3
Advertisement
Table of Contents
