Table 6-1. Sc-2054 Connectors - National Instruments SC-2072 User Manual

Chapter 6 SC-2054
DIO-96 or 6508
Connectors
J1, J2 50-pin male connectors
J3, J7 50-pin male connectors
J3 is tied to PPI A (ports 0 to 2)
or PPI C (ports 6 to 8),
depending on which half of the
type NB5 or R1005050 cable is
attached to J1. J7 is tied to
PPI B (ports 3 to 5) or PPI D
(ports 9 to 11), depending on
which half of the type NB5
cable is attached to J1.
SC-205X Series User Manual
CB-50
J1 or J2
SC-2054
J1 or J2
Type NB5 Cable
SC-2054
or R1005050
J3/J7
CB-50,
16-Channel or
24-Channel
SSR Series
Table 6-1 describes the connectors on the SC-2054.

Table 6-1. SC-2054 Connectors

Connection
Port C
J4
Port B
J5
Port A
PPI A/C J6
PPI B/D
Port C
J8
Port B
J9
Port A
J10
Figure 6-2. SC-2054 Connections
Description
Attach J1 or J2 to the DAQ device via a type NB5
or R1005050 cable. The other connector can
daisy-chain the 48-channel digital I/O signals to
other 50-pin accessories such as a CB-50.
Connect J3 or J7 to any DIO-24 accessories or
daisy-chain the 24-channel digital I/O signals to
other 50-pin accessories such as a CB-50 or a
16-channel or 24-channel SSR Series board.
6-4
SC-206 X Series or
8-Channel SSR Series
SC-206 X Series or
8-Channel SSR Series
SC-206 X Series or
8-Channel SSR Series
SC-206 X Series or
8-Channel SSR Series
SC-206 X Series or
8-Channel SSR Series
SC-206 X Series or
8-Channel SSR Series
© National Instruments Corporation