Table of Contents
Advertisement
1 Clear CMOS Contents
LabVIEW RT Installation
LabVIEW RT Software Installation
© National Instruments Corporation
2 Pin 1
Figure 2-3. Clearing the CMOS Contents
This section explains software installation and switch configuration for
LabVIEW RT on your PXI controller.
The following section describes the necessary steps to get your PXI
embedded controller setup to run LabVIEW Real-Time. In this section you
will configure the boot mode of the controller, verify or change IP settings,
and install LabVIEW Real-Time software.
Chapter 2
1
3
3 Normal Operation (Default)
2-17
Installation and Configuration
2
NI PXIe-8130 User Manual
Advertisement
Table of Contents
