National Instruments NI PXIe-8130 User Manual page 69

Caution Do not leave the jumper on pins 2–3. Doing so decreases battery life. Also, the
controller will not boot.
1 Clear CMOS Contents
© National Instruments Corporation
3. Move the jumper on W2 from pins 1–2 to pins 2–3 as shown in
Figure 5-1.
4. Wait one second. Move the jumper back to pins 1–2.
5. Reinstall the controller in the chassis.
2 Pin 1
Figure 5-1. Clearing the CMOS Contents
1
3
3 Normal Operation (Default)
5-3
Chapter 5 Troubleshooting
2
NI PXIe-8130 User Manual