Table of Contents
Advertisement
LabVIEW RT Installation
LabVIEW RT Software Installation
Tip
You can connect a monitor to the desktop PC to display startup messages such as the
IP address and MAC address.
© National Instruments Corporation
This section explains software installation and switch configuration for
LabVIEW RT on your PXI controller.
The following section describes the necessary steps to get your PXI
embedded controller setup to run LabVIEW Real-Time. In this section you
will configure the boot mode of the controller, verify or change IP settings,
and install LabVIEW Real-Time software.
Complete the following steps to install the LabVIEW RT software.
1.
Boot the NI PXI embedded controller into the real-time operating
system. Refer to the
the
LabVIEW RT Options Setup Menu
configure the controller for booting into LabVIEW RT.
The PXI controller will automatically boot into LabVIEW RT Safe
Mode when no software is installed. LabVIEW RT Safe Mode loads
with the basic real-time operating system and will automatically
attempt to connect to the network using DHCP. If DHCP is not
available, it will then connect to the network with a link-local
IP address.
2.
Open Measurement & Automation Explorer (MAX) on another
computer in the same subnet and expand the Remote Systems
branch. MAX lists the PXI controller as the model name of the
controller followed by the MAC address (for example,
NI-PXI-8108 00802f108562).
3.
Click on the appropriate PXI controller entry to access the Network
Settings tab in the right pane view.
(Optional) Enter a name for the RT target in the Name text box.
4.
5.
Set the network configuration options of the RT target in the
IP Settings section and click the Apply button.
For information about configuring network settings, refer to the
Configuring Network Settings book, accessible by browsing to
MAX Remote Systems Help»LabVIEW Real-Time Target
Configuration»Configuring Network Settings from the Contents
tab of MAX Help.
Chapter 2
LabVIEW RT Configuration Switches
2-17
Installation and Configuration
section or
section in this manual to
NI PXI-8108 User Manual
Advertisement
Table of Contents
