Toro Reelmaster 3555 Series Installation Instructions Manual page 2

Determining the
Roller-Brush Orientation
All cutting units are shipped with the counterweight
mounted to the left end of the cutting unit. Refer to
Figure 1 to determine the position of the roller brush
and reel motors.
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
Note:
These instructions and illustrations show the
installation of the kit on cutting units with the universal
groomer mounted on the left end of the cutting unit.
Figure 1
5. Cutting unit 5
6. Reel motor
7. Right roller-brush drive
assembly
8. Left roller-brush drive
assembly
Installing the Roller Brush
Installing the Roller-Brush
Assembly
1. If the cutting units are installed on the traction
unit, park the machine on a level surface,
engage the parking brake, shut off the engine,
and remove the key.
2. Remove the grease fitting for the roller from the
side of the cutting unit that has the roller-brush
housing (Figure
g027187
1. Grease fitting
3. Install the 90-degree grease fitting so that it
faces rearward
1. 6 mm (1/4 inch) spacer
2. Side-plate mounting flange 5. Washers
3. 90-degree grease fitting
4. Remove the 2 flange locknuts and 10 washers
securing each roller bracket to the side plates,
2
3).
Figure 2
(Figure 2).
Figure 3
4. Flange locknuts (remove)
g032170
g221188