Toro Reelmaster 3555 Series Installation Instructions Manual page 6

Installing the Drive Pulley
1. Restrain the reel for installation; refer to
Restraining the Reel for Installing Threaded
Inserts (page 12).
2. Install the drive pulley onto the groomer shaft
(Figure 12).
Figure 12
1. Drive pulley
3. Apply 242 Loctite (blue) to the flange-head bolt
and use the bolt to secure the pulley to the
driveshaft; refer to
4. Torque the bolt to 20 to 26 N∙m (15 to 19 ft-lb)
Important:
If you do not properly torque the
bolt, the bolt will come loose.
2. Flange-head bolt—torque
to 20 to 26 N∙m (15 to 19
ft-lb)
Figure 12.
Installing the Belt
1. Install the belt onto the pulleys as follows:
•
Loop the belt around the drive pulley and
then over the top of the idler pulley
13).
1. Drive pulley
2. Idler-pulley assembly
g192352
•
Start the belt on the driven pulley
14).
•
Use a deep-well socket (9/16 inch) to rotate
the brush assembly and guide the belt onto
the driven pulley
6
Figure 13
3. Belt
4. Driven pulley
(Figure
(Figure 14).
(Figure
g192353