Auxiliary Dc Jack - Yamaha X-MAX 400 ABS 2018 Owner's Manual

Instrument and control functions

Auxiliary DC jack

WARNING
To prevent electrical shock or short-
circuiting, make sure that the cap is
installed when the auxiliary DC jack
is not being used.
NOTICE
The accessory connected to the
auxiliary DC jack should not be used
with the engine turned off, and the
4
load must never exceed 12 W (1 A),
otherwise the fuse may blow or the
battery may discharge.
This vehicle is equipped with an auxil-
iary DC jack located within storage
compartment A.
A 12-V accessory connected to the
auxiliary DC jack can be used when the
main switch is in the "ON" position and
should only be used when the engine is
running.
To use the auxiliary DC jack
1. Open storage compartment A.
(See page 3-9.)
2. Turn the main switch off.
3. Remove the auxiliary DC jack cap.
1
1. Auxiliary DC jack cap
4. Turn the accessory off.
5. Insert the accessory plug into the
EAU78213
auxiliary DC jack.
EWA14361
1
ECA15432
1. Auxiliary DC jack
6. Turn the main switch on, and then
start the engine. (See page 6-2.)
7. Turn the accessory on.
4-30