Auxiliary Dc Jack - Yamaha AG200FEB 2011 Owner's Manual

Auxiliary DC jack

1
1. Auxiliary DC jack
2. Dust cap
NOTICE
The accessories connected to the
auxiliary DC jack should not be used
with the engine turned off, and their
combined load must never exceed 6
A or 72 W, otherwise the battery may
discharge.
The auxiliary DC jack is located on the
front carrier.
12-V accessories connected to this
jack can be used when the key is in the
"ON" position and should only be used
when the engine is running.
INSTRUMENT AND CONTROL FUNCTIONS
EAU15403 Refer to the following chart for correct
usage.
Amperage chart
Idling speed
Headlight/taillight "ON"
2 Headlight/taillight "OFF"
To use the auxiliary DC jack
1. Turn the key to "OFF".
2. Remove the dust cap from the re-
ceptacle.
3. Insert the accessory plug into the
receptacle and secure it with the
ECA13070 screw-on cap.
4. Turn the key to "ON", and then
start the engine. (See page 6-1.)
5. When the auxiliary DC jack is not
being used, make sure that the
dust cap is installed onto the re-
ceptacle for protection.
12 V, 3 A
12 V, 6 A
4-13
2
3
4
5
6
7
8
9