MICRO-EPSILON scanCONTROL 3000 Assembly Instructions Manual page 7

The connectors for Ethernet and the multifunction port include a screw connector.
Loosen the screws connection before you remove the connector from the socket.
i
Only connect the sensor to the peripheral equipment, if it is disconnected from
the power supply, i.e. only when the operating voltage is switched off. The sensor
needs a warm-up time of typically 20 minutes for high precision measurements.
8. First Profile
Now start the scanCONTROL Configuration Tools software. Click on Display
Profiles in the main window.
If the software shows the error message No scanCONTROL found in the status line,
please check the Ethernet connection between scanCONTROL and the PC.
On the left side you can adjust the settings for your measurement task, the right side
shows the profile data and information about the measurement.
9. How to Access Profile Data
Profile data of scanCONTROL can be accessed via:
- GigEVision and GenICam for digital cameras via Ethernet interface
- SDK for fast application integration (C, C++, C# and others)
Please refer to the respective SDK documentation for further information on accessing
the profile data.
scanCONTROL 3000 / 3050 Page 7