HPE Apollo 4530 Gen9 Setup And Installation Manual page 27

The chassis requires rails for installation in a rack. To install the rack rails, see the Quick Deploy Rail
System Installation Instructions that ship with the rack hardware kit.
You can install up to nine chassis in a 36U, 1200mm deep rack. If you are installing more than one
chassis, install the first chassis in the bottom of the rack, and then install additional chassis by moving up
the rack with each subsequent chassis. Plan the rack installation carefully because it is difficult to change
the location of components after they are installed.
WARNING: To reduce the risk of personal injury or damage to the equipment, be sure that:
• The rack is bolted to the floor using the concrete anchor kit.
• The leveling feet extend to the floor.
• The full weight of the rack rests on the leveling feet.
• The racks are coupled together in multiple rack installations.
• Only one component is extended at a time. If more than one component is extended, a rack
might become unstable.
WARNING: To reduce the risk of personal injury or equipment damage, be sure that the rack is
adequately stabilized before installing the chassis.
WARNING: To reduce the risk of personal injury or damage to the equipment, you must fully extend
the rails. To fully extend the rails, press the push tabs and extend the rails until the rails click twice.
Procedure
1. Extend the rails until they stop.
2. Fully extend the rails by pressing the push tabs and extending the rails until the rails click two times.
Installing the chassis 27