Mounting Interface Board; Setting Switches And Mounting Optional Boards; Table 3.13 Interface Boards With Jumpers/Switches - Samsung OfficeServ 7200 Installation Manual

CHAPTER 3. Ошибка! Используйте вкладку "Главная" для применения 제목 1 к тексту, который должен здесь
отображаться.

3.3 Mounting Interface Board

This section describes how to set jumpers and switches of an interface board, how to mount
optional boards to an interface board, and how to mount interface boards into slots.

3.3.1 Setting Switches and Mounting Optional Boards

Interface boards that are equipped with switches/jumpers used for accommodating user
requirements or system configuration, and those with connectors for optional boards are as
follows:
Control Interface
Board
MP20 WIM
only
MP20, TEPRIa
Mp20S
MP20, PLIM
Mp20S
MP20, PLIM2
Mp20S
MP20, GPLIMT
MP20S
MP20 GSIMT
only
MP20 4BRI
only
MP20S 2BRM
only
MP20 4HTRK
You have to set the same jumper selection for all the GSIMT, GPLIMT, and PLIM cards.
That is, set all of them to either 'EXT' mode or 'INT' mode.
3-14

Table 3.13 Interface Boards with Jumpers/Switches

Jumpers/S
board witches
JP1~JP4
S2 (1~4)
J1, 2, 3
J2, 3, 4
J1~J4
J13~J14
SW1~SW8
S1 (1~4)
P101, P201,
P301, P401
Description
Sets whether to use the Ethernet port of the front panel or
the back panel when connecting to the LIM board.
Setup of T1, E1, T1/E1, PRI, 24B+D/24B, User/Network,
13H
Determines if you use an internal PSU or an external
rectifier.
Determines if you use an internal PSU or an external
rectifier.
Selects a -54 V power source for the PoE.
- EXT: -54 V is supplied from an external PoE power
module.
- INT: -54 V is supplied from the system power device.
Selects a -54 V power source.
- EXT: -54 V is supplied from an external PoE power
module.
- INT: -54 V is supplied from the system power device.
Sets OFF for NT mode or ON for S0 mode
Sets OFF for NT mode or ON for S0 mode
Set E & M type for Korea or USA
- Type 5 for Korea: connect 2-3, 4-5
- Type 1 for USA: connect 1-2, 5-6
© SAMSUNG Electronics Co., Ltd.