Samsung OfficeServ 7200 Installation Manual page 12

Ошибка! Используйте вкладку "Главная" для применения 제목 8,표준 제목 1 к тексту, который должен здесь
отображаться.
Non-allowed AC Power Connection to Other Equipment
Do not use the AC power of the OfficeServ 7200 or the DC power of an external
battery to operate other equipment.
Caution for Installation
Only a trained service staff can install the OfficeServ 7200.
The equipment intended only for installation in a RESTRICTED ACCESS
LOCATION.
Check the power when mounting or dismounting boards
Mount/Dismount a board to/from the slot of the cabinet after powering off the
cabinet. If not, it may cause damage in the board or a fire.
Mounting the GSIMT board
Only one GSIMT board can be mounted per the cabinet. If you mount boards
more than the capacity limit, it may cause malfunction of the PSU due to
overload.
Mounting the GPLIMT Board
Only one GPLIMT board can be mounted per the cabinet. When using an
external rectifier, up to two boards can be mounted. If you mount boards more
than the capacity limit, it may cause malfunction of the PSU due to overload.
Mounting the OAS in 16 channels slot
If the OAS is mounted on one of 16 channels slot, no board can be mounted on
the other slot. If any board is mounted on the other slot, the board will not work.
(If the slot 1 is occupied with the OAS, the slot 2 should be empty. And if the slot 2
is occupied with the OAS, the slot 1 should be empty.)
Removing Cables
Replace a board after removing all cables connected to the board.
Resetting the Board
You have the reset to board to apply the new settings. If the board is not reset
correctly, it may cause product malfunction.
VIII
© SAMSUNG Electronics Co., Ltd.