BLOTZ B15-CS-251 Instructions

15 mm office block - middle floor

15mm Office Block – Middle Floor

B15-CS-251

Please read these instructions fully before starting construction.

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and

remember to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place

while you allow glue to dry.

We suggest you paint the component parts of your model prior to assembly (see below).

Start by removing the walls and base from the

sprue.

Take the window pieces.

Take the upper strips.

Glue the walls into the base – they will extend out of

the bottom of the base by around 2mm.

Using the holes in the base to align them, stick these

inside the walls as shown above.

Glue one to the top of each wall as shown.

Table of Contents

Need help?

Do you have a question about the B15-CS-251 and is the answer not in the manual?

Page 1 15mm Office Block – Middle Floor B15-CS-251 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
Page 2 Take the lower strips. Glue them into position using the lines etches into the walls to align them. The completed level. Painting We removed the four window sections from the sprue and sprayed these grey using a car undercoat aerosol, then we sprayed the rest of our model white while it was still on the sprues using a white car undercoat aerosol spray.