Advertisement
Quick Links
15mm HQ Complex
B15-MC-005
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the Floor and inner walls from the sprue.
Take the corner walls.
Glue the top ring into position.
These glue over the top of the inner walls so that the
doors / windows can be seen through the gaps.
(see pic above)
Glue the walls to the base so that the etched details
face outwards (see pic)
Glue these into place.
The outer wall pieces.
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for BLOTZ B15-MC-005
Summary of Contents for BLOTZ B15-MC-005
- Page 1 15mm HQ Complex B15-MC-005 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
- Page 2 Take the ring and inner roof pieces from the sprue. Glue these into place as shown above. Take the roof supports Glue the four supports with the line on them to the Note: four of these have a line etched onto them. corners of the roof.
- Page 3 Glue the door surrounds and side strips to the model. The corridor roof pieces. Glue them together as shown above. Place (do not glue) the roof onto the corridor. The completed model.
Need help?
Do you have a question about the B15-MC-005 and is the answer not in the manual?
Questions and answers