Advertisement
Quick Links
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Take the three small walls and their roof from sprue as
shown above.
..;then glue the roof on top.
Glue the assembly to it as shown.
Glue those four walls plus the rear wall into place.
15mm Nuclear Power Station
B15-PS-004
Please read these instructions fully before starting construction.
Glue the three walls together....
Take the back wall.
Take the other four walls and the base from the
sprue.
Glue the roof into position.
Advertisement
Related Manuals for BLOTZ B15-PS-004
Summary of Contents for BLOTZ B15-PS-004
- Page 1 15mm Nuclear Power Station B15-PS-004 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
- Page 2 Take the wall pieces shown above from the sprue. Glue all of the shorter pieces and two of the longer ones into place. Attach the cap by inserting the lugs from each walls Carefully lift the cap enough to get the top lugs of piece in turn.
- Page 3 Work around the dome adding each panel in turn. The completed dome. The completed power station. If you do not glue the dome in place, it can be swapped out for a radar dish, turning the building into a radar station.
Need help?
Do you have a question about the B15-PS-004 and is the answer not in the manual?
Questions and answers