Anti-Tip Bracket; 90° Door Stop - Sub-Zero DEU1550B/L Installation Manual

Site Preparation

Anti-Tip Bracket

WARNING
To prevent the unit from tipping forward, the anti-tip
bracket must be installed.
The anti-tip bracket should be attached to the wall behind
the unit with the bracket flange located 1/4"
top of the unit. Refer to the illustration below. Failure to
properly position the anti-tip bracket will prevent proper
engagement.
ANTI-TIP
BRACKET
1
/ "
4 (6)
Anti-tip bracket
90° Door Stop
The door stop pins provided with the unit limit the door
swing to 90°.
IMPORTANT NOTE: If a 90° door opening is desired, the
pins must be installed prior to installing the unit into the
opening.
To install, open the door to approximately 80°. Insert one
above the
(6)
pin into each hinge. Refer to the illustration below.
DOOR STOP PIN
90° door stop
subzero.com | 7