Philips AquaTrio 9000 Series Instructions Manual page 38

English
38
Problem
There is more water on the
floor or in the After-Clean
tray than usual.
The appliance leaves water
traces on the floor.
The appliance does not clean
as well as it used to.
Possible cause
The water channel of the wet
module and/or AquaSpin
nozzle is polluted or blocked.
The dirty water tank is not
placed correctly.
You have moved the appliance
sideways.
You made strong turns with
the appliance.
You have lifted the appliance
over a threshold, carpet or
stairs.
You lifted the appliance up
from the floor immediately
after you switched it off.
The wheels are blocked.
The clean water tank is empty.
The water strips are blocked.
Solution
Use the cleaning brush and clean the water
channel of the wet module and/or
AquaSpin nozzle (see 'Removing blockages
from the Vacuum & Mop set-up').
Place the dirty water tank into the
appliance properly. It is closed correctly
when you can hear a 'click' sound.
To prevent water traces on the floor, try to
make less strong turns with your AquaTrio
9000 Series and avoid moving the
appliance sideways. You can activate the
water absorption mode
cleaning mode button. All the remaining
water on your floor will be absorbed.
To prevent water traces on the floor, try to
make less strong turns with your AquaTrio
9000 Series and avoid moving the
appliance sideways. You can activate the
water absorption mode
cleaning mode button. All the remaining
water on your floor will be absorbed.
Make sure the microfiber brushes stay in
contact with the floor. If available, make
sure water absorption mode
on before you lift the appliance over a
threshold, carpet or stairs to prevent water
traces on the floor or to prevent water from
splashing from the AquaSpin nozzle (see
'Usage restrictions').
If available, switch on water absorption
mode to absorb any remaining water.
Move the appliance forwards and
backwards a few times with water
absorption mode engaged before
switching it off. If you switch off the
appliance and lift it up immediately
afterwards, the water that was present
between the brushes leaves a trace of
water on the floor (see 'Usage restrictions').
Check the condition of the wheels. Remove
the dirt that blocks the wheels.
Refill the clean water tank.
Remove the two microfiber brushes, fill the
clean water tank with some water, and
switch the appliance on. Make small
forward and backward movements on the
by pressing the
by pressing the
is switched