Philips AquaTrio 9000 Series Instructions Manual page 14

English
14
Tips and other important information
Usage restrictions
-
When the system is activated, the appliance switches off and the i3 message
appears on the display (see 'Display icons and their meaning'). The active
protection system can also be activated when the microfiber brushes are too
wet, when you move the appliance over a carpet or a rug, or when you move
it over flooring that is not properly affixed.
-
It is not necessary to vacuum the floor before mopping, as the Vacuum &
Mop set-up actively wet-cleans your hard floor to capture all kinds of dirt,
including liquids and stains. On carpets and rugs, use the Vacuum only set-up.
-
You can move the appliance just as quickly as a vacuum cleaner. To remove
difficult stains, click the cleaning mode button to activate intense wet mode
and move the appliance slowly over the stains.
-
The appliance can leave a small puddle of water on the floor if you do not
move the appliance while switching it off. You can reduce the size of the
puddle by moving the appliance while switching it off. If needed, you can
remove the last drops with a cloth.
-
It is recommended to activate water absorption mode
appliance over a threshold, carpet or stairs. This will prevent dirty water from
dripping out of the AquaSpin nozzle.
-
To prevent water traces on the floor, try to make less strong turns with your
AquaTrio 9000 Series and avoid moving the appliance sideways. You can
activate the water absorption mode
All the remaining water on your floor will be absorbed.
-
When moving the appliance, it is recommended to stretch your arm to reduce
unnecessary tension on the muscles. In this position, you have the best
control over the appliance when cleaning, and it will be the most
comfortable.
Note: When you use the water absorption mode
out of the appliance and the suction power increases. After 45 seconds, if you
do not take any action, the appliance automatically switches back to normal
wet mode .
Note: older models feature normal wet mode
but not water absorption mode
while switching it off to reduce the amount of water left on the floor. It is also
recommended to leave the appliance on when lifting it over a threshold,
carpet or stairs. This will prevent dirty water from dripping out of the
AquaSpin nozzle.
-
The Vacuum & Mop set-up is suitable for vacuuming and mopping all types of
hard floors, except uncoated wooden floors.
-
The Vacuum & Mop set-up is intended for regular cleaning of hard floors.
Always follow the cleaning instructions for your hard floor when you use this
appliance.
by pressing the cleaning mode button.
, no more water comes
and intense wet mode
. For these models, move the appliance
when lifting the
,