Selecting The Level Of Assistance - Bosch KB069 RW Series Translation Of Original Operating Instructions

1 Press Push assist button for longer than
1 seconds. Hold down the button.
 The battery level indicator goes out and a white
running light in the direction of travel indicates
push assist is ready.
2 One of the following actions must be taken
within the next 10 seconds:
 Push pedelec forwards.
 Push pedelec backwards.
 Make a weaving movement with the pedelec.
 The push assist is activated. The continuous
white bars change colour to ice blue.
 The motor starts to push.
3 Release push assist button on the on-board
computer to switch off motor assistance.
4 Push the push assist button within 10
seconds to reactivate motor assistance.
5 If motor assistance deactivates within
10 seconds, the push assist function switches
off automatically.
Push assist will also switch off automatically if
• the rear wheel blocks
• speed bumps cannot be ridden over
• a part of the body is blocking the bicycle crank
• an obstacle turns the crank further
• the rider pedals
• the plus button or On-Off button is pressed.
The push assist mode of operation is subject to
country-specific regulations and may therefore
differ from the above description or may be
deactivated.
MY23K0a - 52_1.0_02.09.2022

6.19.6 Selecting the level of assistance

The on-board computer is used to configure to
what extent the electric drive should assist the
rider when pedalling. You can change the level of
assistance at any time while you are cycling.
.
2
Figure 174: Position of plus and minus buttons
 Press the plus button (2) on the on-board
computer to increase the level of assistance.
 Press the minus button (1) on the on-board
computer to reduce the level of assistance.
 The motor power used is displayed in colour in
the level of assistance indicator.
If the system is switched off, the level of
assistance last displayed is saved.
Operation
1
175