Installation; Placing Of The Ice Maker - PRODIS C Series Technical Manual

2. INSTALLATION

2.1.- PLACING OF THE ICE MAKER

This ice maker is not designed for outdoor operation. The icemaker should not be located next to ovens,
grills or other high heat producing equipment.
The ECO machines are designed to operate at room temperature between 10ºC and 43ºC. There may
be some difficulties in ice cube removal under the minimum temperatures. Above the maximum
temperature, the life of the compressor is shortened and the production is substantially lower.
The air flow in air-condensed machines enters through the front grille, entering on the right front and
exiting on the left front side. In addition, the unit is equipped with a rear air vent. Do not obstruct the front
grille with any objects.
The unit can operate embedded, but with a reduction in output.
In case the front louver is not enough, the exit is either total or partially obstructed or due to its
placement it will receive hot air from another device, we recommend, in case it is not possible to change
the location of the machine, TO INSTALL A WATER CONDENSER.
IT IS IMPORTANT THAT THE WATER PIPING DO NOT PASS BY OR NEAR SOURCES OF HEAT SO
AS NOT TO LOSE ICE PRODUCTION.
The location must allow enough clearance for water, drain and electrical connections in the rear of the
ice machine. It is important that the water inlet piping does not pass near sources of heat so as not to
lose ice production.
7