Electrical Connection; Prior Checking And Start-Up; Prior Checking - PRODIS C Series Technical Manual

2.5.- ELECTRICAL CONNECTION

It is mandatory to ground the equipment. To avoid possible electric shock on individuals or damages to
the equipment, the machine should be grounded pursuant local and/or national regulations as the case
may be.
The manufacturer shall be held harmless in case of damages arising due to the lack of the ground
installation.
In case the supply cable is damaged, it should be replaced by a cable of special assembly to be
furnished by the manufacturer or after-sales service. Such replacement should be performed by qualified
technical service only.
The machine should be places in such a way as to allow a minimum space between the back and the
wall to allow an easy access and without risks to the cable plug.
Safeguard the socket. It is convenient to install adequate switches and fuses.
ATTENTION: The appliance requires an independent power supply of proper capacity. See the
nameplate for electrical specifications. Failure to use an independent power supply of proper capacity
can result in a tripped breaker, blown fuse, damage to existing wiring, or component failure. This could
lead to heat generation or fire.
Voltage is indicated in the nameplate and on the technical specifications section of this manual. Variation
on voltage above the 10% stated on the nameplate could result on damages or prevent the machine
start-up.

3. PRIOR CHECKING AND START-UP

3.1.- PRIOR CHECKING

a) Is the machine leveled?
b) Voltage and frequency are the same as those on the nameplate?
c) Are the drains connected and operating?
d) Will the ambient temperature and water temperature remain in the following range?
ROOM
43ºC
MAXIMUM
WATER
30ºC
11