Introduction; Warning - PRODIS C Series Technical Manual

1. INTRODUCTION

Thank you for purchasing a 'ECO' Ice Cube Maker. You have purchased one of the most reliable ice-
making products on the market today.
Carefully read the instructions contained in this manual since they provide important information relative
to safety during installation, use, and maintenance.

1.1.- WARNING

This appliance is intended to be used in household and similar applications such as staff kitchen areas in
shops, offices and other working environments; farmhouses and by clients in hotels, motels and other
residential type environments; bed and breakfast type environments; catering and similar non-retail
applications.
The installation of this equipment should be done by the Service Department.
The socket should always be placed on an accessible location.
When positioning the appliance, ensure the supply cord is not trapped or damaged.
Do not locate multiple portable socket-outlets or portable power supplies at the rear of the appliance.
Always disconnect the power supply from the machine before any cleaning or maintenance service.
Any change needed on the electrical installation for the appropriate connection of the machine, should
be exclusively performed by qualified and certified professional personnel only.
Any use by the ice maker not intended to produce ice, using potable water, is considered inappropriate.
It is extremely dangerous to modify or intend to modify this machine and will void warranty.
The appliance is not to be used by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction.
Children being supervised not to play with the appliance.
Connect to potable water supply only. To see "Installation" chapter (5).
This machine is not intended to be used outdoors nor exposed to the rain.
The machine should be connected using the power cord supplied with the equipment.
In case the supply cable is damaged, it should be replaced by a cable of special assembly to be
furnished by the manufacturer or after-sales service. Such replacement should be performed by qualified
technical service only.
It is mandatory to ground the equipment to avoid possible electric shock on individuals or damages to
the equipment. The machine should be grounded pursuant local and/or national regulations. The
4