Related Manuals for Jet XACTA FENCE II Homeshop 52
Summary of Contents for Jet XACTA FENCE II Homeshop 52
- Page 1 OWNER’S MANUAL XACTA FENCE II™ Homeshop 30/52 JET EQUIPMENT & TOOLS, INC. P.O. BOX 1349 253-351-6000 A WMH Company Auburn, WA 98071-1349 Fax 253-939-8001 www.jettools.com e-mail jet@jettools.com M-708928X 3/01...
-
Page 2: Replacement Parts
JET’s warranty, then the user must bear the cost of storing and returning the product. This warranty gives you specific legal rights, and you have other rights, which vary, from state to state. JET Equipment & Tools • • • • P.O. Box 1349, Auburn, WA 98071-1349 • • • • (253) 351-6000... - Page 3 You need to have four bolts attaching the extension table to the front and rear rails. Use a JET extension table or one designed and built by the operator. If you are planning to build a table, see Figure 1 for the dimensions.
- Page 4 have the front rail parallel to the table top 2. Place a leg bracket into the outboard end of than exactly 7/8” below the table top. the table and mark all of the holes. 4. Tighten both hex cap screws. 3.
- Page 5 Note: You may need to re-adjust the clamping Guide Rail Assembly pressure after aligning the fence. 1. Bolt the guide rail to the front rail with 1/4-20 x 3/4” hex cap screws, 1/4" flat washers and Clamping Pressure 1/4" lock washers. Center the bolt heads in the slotted holes of the rail so you will have some lateral adjustment.
- Page 6 90° ° ° ° to the Table 1. Place the fence on the saw table and lock it. 2. Place a square on the table next to the fence. The fence should be 90° to the table, see Figure 6. 3.
- Page 7 6..1/4-20 x 3/4” hex cap screws The specifications in this manual are given as general information and are not binding. JET Equipment and Tools reserves the right to effect, at any time and without prior notice, changes or alterations to...
- Page 8 Parts Breakdown...