15. Excessive air pressure and too much free Do not use this tool for other than its intended rotation may decrease life of the tool and may use. If used for other purposes, JET disclaims cause a hazardous situation. any real or implied warranty and holds itself 16.
Page 3
32. Do not lubricate the tool with combustible activities contain chemicals known to the State liquids, such as kerosene, diesel or jet fuel. of California to cause cancer and birth defects or other reproductive harm. Some examples of 33. Do not dispose of this tool with normal these chemicals are: household waste.
As with any tool operation, safety of operator and bystanders should be first priority. If there are questions or comments, please contact your local supplier or JET. JET can also be reached at our web site: www.jettools.com.
Specifications were current at time of publication, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations.
If tool is not accomplishing task at and retainer slot should align with groove on maximum air pressure and flow, use a larger cylinder. tool or different means to achieve task. JCT-3620A Series Chipping Hammers...
Air System Requirements Tool Pressure Use proper air hose size (refer to tool JET Air Tools operate on 70-to-100 psi (pounds specifications). The hose should be just long per square inch) air pressure measured at the tool enough to serve the working area. Excessive when the tool is operating.
Page 8
Use a light oil containing rust inhibitors, such as When using multiple hoses, air hoses should be SAE #10. Many JET air tools have integral oil larger than leader hose. Join multiple hoses reservoirs, which should be kept filled when in-line directly, rather than with quick connect fittings oilers are not used.
Page 9
Troubleshooting JCT-3620A Series Chipping Hammers Any disassembly of the tool should be done by qualified service personnel. For problems not addressed below, contact JET technical service at 800-274-6846. Problem Possible Cause Remedy Tool will not start. Air valve closed or obstructed.
Non-proprietary parts, such as fasteners, can be found at local hardware stores, or may be ordered from JET. Some parts are shown for reference only, and may not be available individually. JCT-3620A Series Chipping Hammers...
Page 11
#550620, JCT-3620A 3 in. Stroke Chipping Hammer, Round Shank Index Part No. Description Index Part No. Description JCT3620A-01 Cylinder 15 JCT3620A-15 Spacer JCT3620A-02 Handle 16 JCT3620A-16 Piston JCT3620A-02A Handle Assembly 17 JCT3620A-17 Flange Bolts JCT3620A-03 Air Inlet 18 JCT3620A-18 Exhaust Deflector Ring...
Accessories; Shop Tools; Warehouse & Dock products; Hand Tools; Air Tools NOTE: JET is a division of JPW Industries, Inc. References in this document to JET also apply to JPW Industries, Inc., or any of its successors in interest to the JET brand.
Page 16
427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.jettools.com JCT-3620A Series Chipping Hammers...