Advertisement
Note: This manual also runs through the steps of installing the rails, and extension table.
Disconnect the table saw from the power source before attempting any assembly or adjustment!
Contents of the Shipping Containers
1
XACTA FENCE II™
1
Front Rail
1
Rear Rail
1
Guide Rail
1
Hardware Package
3
Black Plastic End Caps
1
Owner's Manual
1
Warranty Registration Card
Front and Rear Rail Assembly
Note: The hardware should be packed in the
guide rail along with the end caps.
Assembly Note: Depending on the size of the
extension table you are using, you may need to
remove the right side extension wing. You need
to have four bolts attaching the extension table
to the front and rear rails. Use a JET extension
table or one designed and built by the operator.
If you are planning to build a table, see Figure 1
for the dimensions.
1. With a 5/16" drill bit, drill out the two
threaded holes on the table front only.
Note: By drilling out the threads you will
gain the needed room for adjustment of the
front rail.
2. Bolt the front rail to the table in the two
holes you drilled out (not to the extension
wing at this time). Use two 1/4"-20 x 1-1/4"
hex cap screws, four 1/4" flat washers, two
1/4" lock washers and two 1/4" hex nuts.
Tighten just enough to hold the rail next to
the table but keep loose enough to allow
height adjustment. Center the bolt heads in
the slotted holes of the rail so you will have
some lateral adjustment.
3. Place the combination square on the table
and adjust the top of the rail so that it is
approximately 7/8" below the table surface,
see Figure 2. Note: It is more important to
XACTA FENCE II™ HOMESHOP 30/52
WARNING
Failure to comply may cause serious injury!
3
Tools Required for Assembly & Adjustment
1
#3 Cross Point Screwdriver
1
7/16" Wrench
1
1/2" Wrench
1
Combination Square & Straight Edge
1
Electric Drill
1
1/4", 3/16", 5/16" Drill Bits
2
4"-6" C-Clamps
1
1/4", 3/16" Allen Wrenches
Advertisement
