Table of Contents
Advertisement
3. Installation
CAUTION
The machine must not be plugged in and the power switch must
be in the OFF position until assembly is complete.
3.1 UNINSTALL THE OLD SWITCH PLATE
3.1 UNINSTALL THE OLD SWITCH PLATE
- Unscrew the three pan head screws (A-FIG.1) to loosen
- Unscrew the 3pcs pan head screw A-Fig.1, and then unscrew
the plate from headstock.
the small pan head screw B-Fig.1. Then take out the switch
plate.
- Unscrew the two small pan head screws (B-FIG.1) to
loosen the switch plate from inner black box.
3.2 ATTACHING SPUR CENTER ON THE
3.2 UNINSTALL THE TERMINALS
HEADSTOCK
- Unscrew the grounding terminal (A-FIG.2) and uninstall
- Insert spur center, with a No.2 Morse Taper shank, into the
other terminals(B-FIG.2).
headstock spindle. (See FIG.2)
- Remove the black plastic box (C-FIG.2).
3.3 UNINSTALL STRAIN RELIEF
- Uninstall the two strain relief cord holders on the back of
headstock.
FIG.1
FIG. 1
B
FIG.2
A
FIG.3
6
A
B
A
B
B
A
A
B
B
C
Advertisement
Table of Contents
