Setting High-Speed 1:N Nt Links (Standard, High-Speed); Setting Ethernet - Omron NS8-TV0-V2 Setup Manual

6-6 Communications Settings
6-6-3
6-6-4
6-42
Downloaded from Elcodis.com electronic components distributor

Setting High-speed 1:N NT Links (Standard, High-speed)

Select the Comm. Tab from the System Menu, and select NT Link 1:N (1:N NT Link) as the
communications method for serial port A or B.
Press the Detail Button to display the setting items for high-speed 1:N NT Links on the right
side of the screen. Set the unit number and communications speed.
After setting, press the Write Button.
• Communications Conditions for 1:N NT Links
Setting item
Unit number
Communications Speed
Reference
• The unit numbers that can be set depend on the type of host used, as follows:
• C200HE(-Z):
Unit numbers 0 to 3 (up to four PTs for each port of the host)
• C200HG(-Z), C200HX(-Z), CS1G/H, CS1G/H-H, CQM1H, CJ1G, and CJ1G/H-H:
Unit numbers 0 to 7 (up to eight PTs for each port of the host)
• If the Detail Button is pressed for the NS15, the display will switch to the Protocol Set-
ting Dialog Box. Make the settings and press the Write Button. Press the Comm. But-
ton to return to the Comm Tab Page.

Setting Ethernet

To use Ethernet, select the Comm Tab from the System Menu and press the Enable Button.
The setting items for Ethernet will be displayed on the right side of the screen. Display and
set the network address, node address, IP address, subnet mask, and default gateway. Dis-
play the MAC address and IP address table display.
After setting, press the Write Button.
Function
Sets the unit number.
Sets the baud Communications speed.
Refer to 4-2 1:N Host Connection for the host settings.
Settings
0 to 7
Standard, high-speed