Omron NS8-TV0-V2 Setup Manual page 113

Downloaded from Elcodis.com electronic components distributor
• If the connector becomes disconnected, not only will the Board be unable to
Precautions
for Safe Use perform communications with other nodes in the network, the network will be
split into two at the point of disconnection. Take the utmost care to ensure
that the connector does not become disconnected during communications.
• Do not pull on the communications cable.
• When bending the communications cable, allow 60 mm or more for the
bending radius (R).
• Do not place heavy objects on the communications cable.
• Supply power only after checking the wiring thoroughly.
• Always tighten the screws of connector after connecting the communications
cable.
3-8 Installing the Controller Link Interface Unit
Controller Link Support Board
Communications disabled
Connector
Network split
(communications disabled)
3-59