Table of Contents
Advertisement
B. Installing a Television
If installing a television (TV) above the appliance, see
Section 2.B.
C. Mantel and Wall Projections
WARNING! Risk of Fire! Comply with all minimum clear-
ances as specified. Mantel MUST be fastened to wall
with no gaps.
• Framing closer than the minimums listed must be
constructed entirely of non-combustible materials (i.e.,
steel studs, concrete board, etc.).
• No gaps allowed between the wall and the bottom of the
mantel.
• Combustible mantel legs and wall projections may be
applied over the non-combustible board supplied with
the appliance. Follow guidelines as shown in the figures
below for mantels, mantel legs and wall projections.
• Measurement is taken from top/side of the opening, NOT
the top/side of the appliance.
Mantel requirements are shown in Figures 10.4-10.9.
Combustible Mantels
Note:
All measurements
in inches.
4
3
2-1/2
5
Measurement from fireplace
opening to bottom of appliance:
= 33-1/2 IN. (MER36)
= 35-1/2 IN. (MER42)
Note: Measurement is taken from top of the opening,
Figure 10.4 Minimum Vertical and Maximum Horizontal
Dimensions of Combustibles or Painted Surfaces
Majestic • MER36N, MER36L, MER42N, MER42L Installation Manual • 2595-980 Rev. B • 5/23
TO CEILING
18
12
11
10
32
9
8
25
7
19
6
18
5
17
16
15
14
13
12
11
10
Combustible Mantels - Passive Heat Installed
Note:
All measurements
in inches.
12
2-1/2
5
Measurement from fireplace
opening to bottom of appliance:
= 33-1/2 IN. (MER36)
= 35-1/2 IN. (MER42)
Note: Measurement is taken from top of the opening,
NOT the top of the fireplace.
Figure 10.5 Minimum Vertical and Maximum Horizontal
Dimensions of Combustibles - Passive Heat Kit
Installed
TO CEILING
18
17
50
16
12
15
11
14
10
13
9
8
7
6
65
Advertisement
Table of Contents
