Table of Contents
Advertisement
Rear Vent
NOTICE: Once appliance is set up for top or rear venting,
it CANNOT be changed at a later time.
TIN SNIPS
Figure 6.7 Cut Seal Cap Strap Using a Tin Snips and
Bend the Pieces to 90 Degrees
GASKET MATERIAL
Figure 6.8 Remove the White Gasket Material
Covering the Seal Cap
REMOVE SEAL CAP
SEAL CAP STRAPS
Figure 6.9 Remove Seal Cap
NOTICE: Once the seal cap has been removed it CANNOT
be reattached.
Majestic • MER36N, MER36L, MER42N, MER42L Installation Manual • 2595-980 Rev. B • 5/23
48
INNER VENT
INSULATION
INSULATION
BASKET
Figure 6.10 Remove Insulation Basket and Inner
Vent Insulation
VENT GASKET
Figure 6.11 (Generic Fireplace Shown) To attach the
first section of vent pipe, make sure to use the vent gasket
in the manual bag to seal between the first vent component
and the outer fireplace wrap. Seal with four screws or caulk
with a minimum of 300 ºF continuous exposure rating may be
used to hold the part in place.
Secure the first section of venting to the fireplace by screw-
ing through the two straps left over from cutting the seal
cap strap (Figure 6.11).
It is acceptable to use screws no longer than 1/2 in. (13
mm) to hold outer pipe sections together. If predrilling
holes, DO NOT penetrate inner pipe.
SEAL CAP
Advertisement
Table of Contents
