Measuring Procedures; Change The Function - PCE Health and Fitness PCE-T 238-ICA Manual

4. MEASURING PROCEDURE

4-1 Change the function

1) Short press the " TEST(Power) Button " ( 3-2, Fig. 1 ) once,
the meter will power ON,
2) Short Press " Function Button " ( 3-3, Fig. 1 ) momentarily in
sequence, the function will change to
a. Contact RPM measurement, display shows
" RPM " symbol.
b. Surface speed ( m/min. ) measurement,
display shows " m/min " symbol.
c. Surface speed ( ft/min. ) measurement,
display shows " ft/min " symbol.
d. Surface speed ( in/min. ) measurement,
display shows " in/min " symbol.
e. Photo RPM measurement, display shows "
RPM " symbol, at the same the " Laser
Light Beam " ( 3-8, Fig. 1 ) will be generated.
Note :
* After the function be selected,
the function will saved into the meter
even turn off the meter.
* Turn on the meter again, the existing select
function will present .
Remark:
If want to power off ,please short press the" TEST(Power) "
button again, the meter wii be power off.
5