Table of Contents
Advertisement
* If press the button once, the display value will
change with high resolution ( change just with 1
digit ).
* If press the button continuously, the display value will
change with low resolution ( change with more
digits ).
When checking the speed, care must be taken
to ensure that the strobe is flashing in unison
(one to one) with the object being monitored.
2) The Stroboscope will also stop motion at 2:1, 3:1, 4:1 et.,
this is normally referred to as harmonics. To ensure
unison, turn the dial until two images appear - this will
double the actual speed. Then lower the flashing rate
until a single and stationary image appears - this is the
actual true speed.
6-3 Checking Motion
For motion analysis, simply locate the actual speed as
mentioned above and use the " ▲ button " or "▼ button " to adjustment
slowly up or down. This will give a slow motion effect allowing complete
inspection.
7. Type K Thermometer
MEASURING PROCEDURE
1) Power On the meter by short pressing the " Power
button " ( 3-2, Fig. 1 ) >1.5 seconds, the LCD will light.
2) Press the " Function button " ( 3-6, Fig. 1 ) (short push) in
sequence until to the " TYPE k " function be
selected.
3) type k probe inserted into the thermocouple probe terminal
" thermocouple probe terminal " ( 3-12, Fig. 1 ).
The display will show type k probe sensing temperature value.
4)
10
Advertisement
Table of Contents
